FAIL (the browser should render some flash content, not this).

 

TECHNICAL HEATERS

ELECTRICALLY HEATED SERIES 600 RUBBER HOSES

CONSTRUCTION

CORE

 Natural or Synthetic Rubber

HEATING ELEMENT

Spiral Wound Resistance Wire

ELECTRICAL INSULATION

Reinforced Rubber

THERMAL INSULATION

High Temp Fiberglass (not required for freeze protection)

EXTERNAL JACKET

Abrasion Resistant Sleeving or Extruded Polyurethane

ELECTRICAL SPECIFICATIONS

OPERATING VOLTAGE:

Any single phase voltage to 480 VAC. Depending on length, hoses may be ordered to operate on 208, 240 or 480 VAC, 3 phase.

POWER DENSITY:

Power density is based on the desired operating temperature, ambient temperature and size of hose. Our engineering staff will help you determine wattage necessary to maintain temperature required for your application.

POWER/CONTROL CABLE:

Standard length is 4 feet. Longer lengths are available.

TEMPERATURE CONTROL:

Series 600 Heat/Line Hoses must be controlled to maintain the desired operating temperature and to ensure operation within design limits. A sensor for the controller is installed in the hose during construction, and unless otherwise specified, is located 2 ft. from the lead end. For very close temperature control, a solid state proportional controller is recommended.

In freeze protection applications, the hose may be controlled using a built-in thermostat. If the hose current does not exceed the maximum amps allowed, the thermostat may be wired in series with the heater circuit, and will turn power on when the temperature drops to 45 degrees F (7 degrees C). In higher current applications the thermostat is used to signal an auxiliary control relay/contractor.


AVAILABLE OPTIONS

SELF-REGULATING HOSE:

Custom designed to maintain your minimum operating temperature without the need of a controller.

MODULAR:

Hydraulically in series, electrically in parallel. Suitable for individual use or in combinations.

BULK:

Available in lengths of 100 feet or more, to be cut to length as required.



  • Messenger wires available in different gauges & colors.
  • Multiple Sensors
  • Multi-tube
  • FM approved for Class I Div. 2 Group D
  • Color coded
  • Varied watt density
  • Other types of core
 
Applied Thermal Systems, Inc. © 2010 | All Rights reserved